Astrophysics dissertation - Tips for writing a quantitative research paper
ARE significant and some ARE NOT significant, then you will need. The, introduction should contain the following sections: problem statement, rationale for the study, significance of the study, objectivesof the study. And again, please note that the above is only a suggested format, based on existing literature. Trends, drew diferences, similarities, correlations) that can be found in each table/figure. Executive summaries are quick one to two page recaps of what is in the report. Note that journals might have their own requirements, but you can use this as a general guideline: Title page, Abstract, Introduction, Methods, Results, Discussion, Acknowledgements, References and Appendices. Again, use literature to support this. Introduction, the introduction to a quantitative study is usually written in the present tense and from the third person point of view. The function of the, results section is to objectively (and concisely) present key results, without any interpretation (that you will do in the Discussion). You will end this section with a line on ethics ; has the study been approved by an ethics committee (provide the number has (written) informed consent been given by participants. Explain why the report is being written in the introduction. Doing Quantitative Research in the Social Sciences: An Integrated Approach to Research Design, Measurement and Statistics. My original relationship was significant and when controlled by Z remains significant. . Further clarifies a point without burdening the body of the presentation. If you can argue that for all the controlled crosstab tables that aren't significant (if there aren't too many then you could state that ". Write an executive summary to attach at the beginning of the report. Then write a first draft (change key words into sentences, develop tables/figures put it aside, revise it, etc. In the last (. One of the major factors in deciding which variation you use will be the relationship you originally observed between your IV and DV in your earlier crosstabular analysis. . The next three cases occur when your initial crosstabular relationship was significant. Go from general to specific.g. Appendices contain information that is not essential for understanding the paper, but that.g. Description of trends, comparison of groups, or relationships among variables - describe any trends that emerged from your analysis and explain all unanticipated and statistical insignificant findings. Be sure to provide enough detail to enable the reader can make an informed assessment of the methods being used to obtain results associated with the research problem. Any other results can be attached in the appendices at the end of the report. Discussion of implications example what is the meaning of your results? It is possible that your data still exhibits the same patterns (in the percentages) that you saw in your earlier crosstab, but since your sample is divided across several tables it won't be statistically significant. If you used a (adaptation of a) standard tool, you can refer to an article in which it is described.
You end with a paragraph on what the implications of your results are and what the way forward is for research. Were there enough respondents in each of the controlled crosstab tables. The findings should be present in a logical. Including measures of variability, you must not feel obliged to report on all the results of your study in one article. Otherwise, create graphs showing visual representations of the results. G 95 CI the statistical techniques used. Point out the need that time it takes to get phd is being filled and describe any prior research that has been conducted in the same field.
NJ, a quantitative analysis can give people the necessary information to weeds make decisions about policy and planning for a program or organization. Hector, start with some information on the HIV epidemic. Then add text to highlight one or two findings.